![]() ![]() Next open PC Access (1105W) and name all your switches under Setup > Names and Voices. So, I would plug the Interface in, connect it to the board, install a switch, then use the PC Access software to set up the switch? Would it at that point show up in the cable from the PIM to the IIe via the supplied cable. Not all homes need a phase coupler but it is recommended for most installations. You may also need a phase coupler which is part number 39A00-1. You will need to name the switches and this will make your life easier. Isn’t used to configure the switches but very helpful in setting up the panel. Programming Related Questions (Using UPStart Software)ġ) UPB Powerline Interface 36A00-1 – Interfaces HAI to the electrical infrastructureĬorrect! It also comes with the cable needed to connect to the IIeĢ) Cable to connect the Interface to the OmniIIe board Unknown part Numberģ) PC Access Software (Installer version) Unknown part number – Used to configure the switches?ġ105W.Application Related Questions (What Products to Use, When, Where?).General Technology (UPB Related) Questions.About Anywhere Virtual 3-Way Switch Kit.Anywhere Virtual Accessory Remote Devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |